2159 Aptiva - Access Station

Access Station (Media Console) Disassembly

Disconnect the cable for the media console from the tower Remove the two bottom screws Pry off the left and right wing covers as shown in Figure 4-8 Open the media console (aka "Access Station") Press in the tabs on the left and right sides of the bottom cover as shown in Figure 4-9 Snap the On/Off switch assembly out of the front cover and feed it back through the hole in the front cover Pry out the bottom cover at the pivot as shown in Figure 4-9 and raise upward to release the Access Station from the bottom cover Raise the top cover assembly from the bottom cover and remove the spring

Important Note: When reassembling the Access Station to the bottom cover, be sure to put the two ends of the spring in the holes in the bottom of the Access Station frame

BACK